My tado° Internet Bridge has issues connecting to the Internet through my BT Hub router. These settings can usually be accessed via your browser by entering 192.168.0.1 or 192.168.1.1 in the address bar. You will have to enter your router settings to do so. Select a different LAN port in this case.Ĭheck whether DHCP is enabled. Make sure the LAN port you are using is not labeled “IP-TV”. If the lights on the port do not light up when connecting a cable to it, the port is probably disabled and needs to be enabled in the router settings. Reset the Internet Bridge by unplugging the power cable and powering the Internet Bridge back up after a few seconds.Ĭheck if the LAN port is disabled. Try a different Ethernet cable for connecting the Internet Bridge to your router. The status LED signals operational status.
The LED is off when the Ethernet cable is not connected. This LED is normally green when an Ethernet cable is connected, and blinks green when a packet is received or transmitted over the Ethernet infrastructure. Make sure the cable is properly plugged in on both ends. The Ethernet LED signals traffic on the wired LAN, or Ethernet infrastructure. If the ‘Router’ LED keeps blinking, please check the following points:Ĭheck the Ethernet cable connecting the Internet Bridge to the router. Once the IP address has been assigned successfully, the ‘Router’ LED will turn solid.
A blinking ‘Router’ LED on the Bridge means that the ethernet link has been detected and that the Bridge is awaiting DHCP IP address assignment from the router.
0 kommentar(er)
